Rubber mould is used to mold rubber products used in industry or for civil products. The products are very rich and diverse but include such as rubber gaskets, rubber seals, rubber joints, rubber elastic parts, rubber gloves and rubber slippers. There are two ways to create rubber products: rubber dump and rubber molding. Both methods have different advantages and disadvantages, but they have to be molded to cast. As with all other plastic molds, rubber molds need glossy surfaces, beautiful, and other plastic molds that must have grooves cut off. The more accurate the quality of rubber products, the higher the required precision molding and groove cutting should be small to not create a large through the mold.
The mould is made of three pieces, which are precisely bound by six locating pins. As customers request through small so when this rubber mold we are creating cutting groove through the treatment of V with the cut edge of 0.05.
Precision mould IMI 1.2.2 is used to fabricate rubber end caps used in the electrical industry. This product is used in series to replace the plastic products being used due to similar or broken products. After using a time plus Vietnam's hot weather factor, it can not be used for a long time.
Rubber mould characteristics: Precision rubber moulds are assembled by upper and lower molding pieces with machined cavities of 9 products per cast. The molds are made of S50C steel, without heat treatment, the mold must ensure that the cut edge is sharp and the molding of the mold to ensure that when molded rubber surface smooth products. The mold is guided by four standard molds 10.
